Over 10,000 dolls house accessories in-store!
Cart 0

Step by step guide to wallpapering a dolls house

Keely Jones

Step 1

Find out how many sheets of paper you need. Measure your room before buying any paper to find out how many sheets you will need. Sheet sizes can vary so find out the size of the wall paper sheets before you start. Bare in mind that pattern sheets or sheets with a border will have to match up so you may need more to be able to match them correctly.

I normally find that when using a single wall paper in a room I need one sheet per wall if the sheets are big enough to cover a wall. If I am using two wall papers I usually need two or three sheets of each paper.

If you have a front opening house you also have to decide if you will paper the front wall that opens and if so account for this. Always buy more paper than you need in case you make a mistake. Colours can vary slightly between batches of paper and you might not get an exact match.

Step 2

Next you must cut your paper to size. Cut the paper to the required size. The full size of the wall if using one style of paper or if you are using two cut to the length of the wall and the required height. When using two papers overlap the top paper over the bottom slightly to make sure there are no gaps.

Make sure you use a ruler to get a straight edge. Wall paper should already have a straight, right angle corner so you can measure from an existing edge.

Step 3

Before the wall paper goes up there are a few things you must do.

• All wires from electric's should be in grooves to stop them sticking up under the wall paper.
• Wires should be held in place with a thin piece of masking tape.
• Ceilings should be painted

Step 4

You are now ready to hang your wall paper. When doll house wallpapering you need a paste that allows the paper to move freely you can get special wallpaper paste for hanging dolls house wallpaper and you can view details of this in our online store.

An alternative is to use normal household wallpaper paste but this can be a bit lumpy for dolls houses.

Paste the wall of the dolls house and not the paper. If you paste the paper it might become too moist and will tear more easily.

Once you have pasted the wall position the wall paper and flatten with the palm of your hand onto the wall. At this stage you can slide the paper around until you get it in its rightful position. One in the right place flatten and bubbles or creases with the palm of you hand. You may need to apply a little extra paste at the edges.

Leave to dry for a day before you do any other work to avoid ripping.



Older Post Newer Post